Hydrom Instruction
ContactShopDeutsch
  • Introduction
    • Charging the Hydrom
    • Turn on the Hydrom
    • Start in Configuration-Mode
    • Access to the user interface
    • Connect to existing WiFi
    • Do PlainWaterCalibration
    • To set up the Hydrom as an MQTT publisher
    • Connect the Hydrom to Ubidots
    • Connect the Hydrom to Brewblox
    • Connect the Hydrom to Brewfather
    • Connect the Hydrom to Grainfather
    • Connect the Hydrom to Telegram
    • Send Measurements via Webhook
    • Connect the Hydrom to BierBot Bricks
    • Connect the Hydrom to Google Sheets
    • Connect the Hydrom to iRelays Display
    • Connect the Hydrom to Brewers Friend
  • Getting Started
    • Disinfect before use
    • Warnings (read before use)
    • Establish first connection to the hydrom
    • Indicator LEDs
  • Other settings
    • Changing the Hydrom name
    • Customize units
    • Factory Reset
    • Adjust Intervall
    • Activate headstand detection
    • Setting up the temperature compensation
  • Calibration
    • Check calibration status
    • Attitude Sensor Calibration
    • Calibration process
      • Manually change the formula
      • Reference method
  • Bluetooth Settings
    • IOS App
  • Troubleshooting
    • An Internet service does not receive any data
    • The Hydrom user interface cannot be accessed.
  • Firmware
Powered by GitBook
On this page

Was this helpful?

  1. Getting Started

Indicator LEDs

The Hydrom has two different pairs of LEDs.One pair of LEDs shows the charging behavior, the other shows the status of the device.

PreviousEstablish first connection to the hydromNextChanging the Hydrom name

Last updated 1 year ago

Was this helpful?

  1. Status LED of the Hydrom logic. When the Hydrom is in configuration mode, the LED is green. If something has gone wrong, only the red LED is lit.

  2. Charge LEDs. If the battery is fully charged, then the green LED is on. When the battery is charging, the red LED is on.

Position of LED pairs