Hydrom Instruction
ContactShopDeutsch
  • Introduction
    • Charging the Hydrom
    • Turn on the Hydrom
    • Start in Configuration-Mode
    • Access to the user interface
    • Connect to existing WiFi
    • Do PlainWaterCalibration
    • To set up the Hydrom as an MQTT publisher
    • Connect the Hydrom to Ubidots
    • Connect the Hydrom to Brewblox
    • Connect the Hydrom to Brewfather
    • Connect the Hydrom to Grainfather
    • Connect the Hydrom to Telegram
    • Send Measurements via Webhook
    • Connect the Hydrom to BierBot Bricks
    • Connect the Hydrom to Google Sheets
    • Connect the Hydrom to iRelays Display
    • Connect the Hydrom to Brewers Friend
  • Getting Started
    • Disinfect before use
    • Warnings (read before use)
    • Establish first connection to the hydrom
    • Indicator LEDs
  • Other settings
    • Changing the Hydrom name
    • Customize units
    • Factory Reset
    • Adjust Intervall
    • Activate headstand detection
    • Setting up the temperature compensation
  • Calibration
    • Check calibration status
    • Attitude Sensor Calibration
    • Calibration process
      • Manually change the formula
      • Reference method
  • Bluetooth Settings
    • IOS App
  • Troubleshooting
    • An Internet service does not receive any data
    • The Hydrom user interface cannot be accessed.
  • Firmware
Powered by GitBook
On this page
  • Connect Hydrom to a WiFi that already exists
  • Save Settings

Was this helpful?

  1. Introduction

Connect to existing WiFi

PreviousAccess to the user interfaceNextDo PlainWaterCalibration

Last updated 1 year ago

Was this helpful?

Requirement that the Hydrom has for the WiFi:

  • 802.11 b/g/n

  • 802.11 n (2.4 GHz), up to 150 Mbps

  • WiFi name length: max 30 characters

  • WiFi password length: max 63 characters

  • Supported special characters for name and password:

  • a-zA-Z0-9!/#$&'()*+a-zA-Z0-9!/#$

  • Security: WEP/WPA-TKIP/WPA2-CCMP

To change the network settings, open the navigation bar on the left side and select the "Wifi" option

Connect Hydrom to a WiFi that already exists

To set up the Hydrom as a client in an existing network, enter the name of the existing network in the field under "SSID". This setting allows the device to connect to an existing WiFi.

There are services that rely on the Hydrom having access to the Internet. If the Hydrom connects to a WiFi that does not have Internet, only local services will be available.

After you have entered the desired settings, press "Save".

Here is an example of the settings for an existing WiFi:

Save Settings

You can check whether the saving was successful by looking at the settings file at http://hydrom001/settings.json/. to check if the save was successful. This file is the permanent memory of the Hydrom.

A second way to check the saving is to reload the page (all modern browsers offer this Feature). If the properties are then reloaded, the hydrom has accepted them, otherwise the old settings are reloaded.

Example of setting "Hydrom in existing WiFi"
Pressing the "save" button saves the settings.