Hydrom Instruction
ContactShopDeutsch
  • Introduction
    • Charging the Hydrom
    • Turn on the Hydrom
    • Start in Configuration-Mode
    • Access to the user interface
    • Connect to existing WiFi
    • Do PlainWaterCalibration
    • To set up the Hydrom as an MQTT publisher
    • Connect the Hydrom to Ubidots
    • Connect the Hydrom to Brewblox
    • Connect the Hydrom to Brewfather
    • Connect the Hydrom to Grainfather
    • Connect the Hydrom to Telegram
    • Send Measurements via Webhook
    • Connect the Hydrom to BierBot Bricks
    • Connect the Hydrom to Google Sheets
    • Connect the Hydrom to iRelays Display
    • Connect the Hydrom to Brewers Friend
  • Getting Started
    • Disinfect before use
    • Warnings (read before use)
    • Establish first connection to the hydrom
    • Indicator LEDs
  • Other settings
    • Changing the Hydrom name
    • Customize units
    • Factory Reset
    • Adjust Intervall
    • Activate headstand detection
    • Setting up the temperature compensation
  • Calibration
    • Check calibration status
    • Attitude Sensor Calibration
    • Calibration process
      • Manually change the formula
      • Reference method
  • Bluetooth Settings
    • IOS App
  • Troubleshooting
    • An Internet service does not receive any data
    • The Hydrom user interface cannot be accessed.
  • Firmware
Powered by GitBook
On this page

Was this helpful?

  1. Introduction

Turn on the Hydrom

This operation deals with switching on the Hydrom.

There is a label on the circuit board below the switch, which indicates the direction in which the switch contact must be moved.

  1. Open the Hydrom by twisting off the lid.

  2. Slide the switch contact to the center.

  3. The hydrom now starts to DeepSleep mode.

PreviousCharging the HydromNextStart in Configuration-Mode

Last updated 1 year ago

Was this helpful?